120 Degrees Fahrenheit Overheat Thermostat Water DC water heater element 120F

Description

Auction is for one thermostat at the temp rating in header off this ad.
Thermostats are for DC water heating elements up to 600 watts.
Regulates temperature of the liquid you are heating.
Stays within 10 F. up or down
Thermostats can handle 28 amps at 12 to 48 volts.
The higher the voltage the lower the amperage, use OHMS law.
Opens circuit on overheat. Cuts power to the heater when temp is reacted.  Normally closed connectors.
Heating Element Features:
1/4" spade terminal
connections.
The heat sensor (disc) must be firmly mounted on the side of tank with screws or marine grade silicone caulking.
Simple in-line or "loop'" wiring system
'opens' when hot (turns off)
10 gauge wire recommended.
Heat ratings are averages (+ or - 2.9%)
Fahrenheit to Celsius conversions:
35 F = 1.66 C
55 F = 12.77 C
120 F = 48.88 C
140 F = 60 C
170 F = 76.66 C
FYI:  It takes 2.4705 watts for 1 hour to heat one gallon of water up 1 degree?
OTHER ITEMS WE SELL BELOW  (sold separately)
Threaded models
fit right into the bottom of all 1" water tank drain plugs. (1" NPT - bottom tapped)
Built to last a lifetime.
6" long with 1" NPT full thread type
(No taper)
Low voltage means NO shock hazard.
STOP expensive and deadly Colic !
For use on 12 Volt batteries only!!
Good luck bidding