Lincoln Power wave S500 welder plus 25m feeder Crouse hinds ARKTITE , POWERWAVE

Description

Lincoln Power wave S500 welder plus 25m feeder with Crouse hinds ARKTITE 60a 3ph connectors , POWERWAVE.
I have a very nice mig welder set up. This is a LINCOLN POWERWAVE S500 welder with LINCOLN 25M FEEDER.
Welder works great. This setup is for three phase only. 200 to 575v three phase.
The power wave comes with multiple synergic programs for MIG. TIG, stick, and  flux core
For Tig welding you would have to get a tig torch and other things.
This package is set up for Mig or wire feed welding.
ATTENTION. THE TANK IS NOT INCLUDED. IT CANNOT BE SHIPPED.
Package comes with:
POWERWAVE S500 WELDER ser U1131007247   3ph 200-575volts
New 4c/4awg soow feed cable
Crouse Hinds 60amp 3 phase plug and receptacle with angled connector. needs back box.(over 0 for these)
silicon boot that protects the on/off switch is ripped. Switch works fine.
LINCOLN 25M FEEDER
12' 2/0 ground cable with new TWECO 500A ground clamp
6'   2/0 power cable connects feeder to power source
8' Arclink communication cable NEW
Regulator NEW
12' torch  yeswelder NEW
10lb spool of er70s6 .045
.045 drive rolls
There are a couple of small plastic repairs on the inside of the feeder. I can send pics of the repairs. there are two approx inch long repairs to the plastic.
Shop made twin tank cart.
Owners Manual
NO TANK INCLUDED. TANK IS NOT INCLUDED.
This feeder can be extended over 100 feet from the power supply. You just need to get cable extensions. You carry the suitcase right to the job site and extend the cable to the welder.
Please come to Vegas and try the welder. Run some beads.
These machines are used. please expect scratches and scrapes on the plastic suitcase.
The paint on the S500 looks very good.
I can load it on your truck or trailer.
also listed on LV Graigslist. listing can end at anytime. go there for more pics and info
I can assist in strapping to a pallet but freight is completely the responsibility of the buyer.